icon-search
icon-search
  • 344449746_630006755647067_2257455327042438167_n TK50
  • 344510311_605276184886966_6772135155407221563_n TK50
  • 344522191_268282912310502_1643770418608071300_n TK50

TK50 ESP Multi-Function Unit for RC Tank

RM 59.00
- +
icon-bag Add to Cart
Home

TK50 ESP series RC tank Gaming Controller

World's First integrated RC tank controller with Ultrasonic ESC

THIS IS NOT 100% PLUG AND PLAY BOARD, SIMPLE CHANGE IS NEEDED FOR FULL OPTIONS

(specifications and design are subject to change without notice)

Overview

  • TK50 series controller is the successor of successful TK50 controller, uses 4-CH conventional PWM or 10-CH  S.BUS  RC system to control R/C tank's forward/backward movement, sharp turning, pivoting, turret rotation and gun barrel evaluation at variable speed

  • Ultrasonic ESC*3  for two track motor and turret rotation

  • Carefree reversing

  • Ultra Low turn-on resistance FET for track motor ESC

  • Support Gun Barrel Stabilizer ( G2 Variant )

  • 22KHz, 8-bit high quality sound with digital sound mixer

  • Maximum of 5 channel of sound track, main gun, machine gun, turret rotate, gun barrel elevation and engine sound can be generated at the same time

  • 7W sound output power8/4-Ohm Speaker is recommended

  • 0.8A BEC

  • EPM*2 for gun elevation(EPM1) and turret rotation/gun traverses(EPM2) 

  • Wide operating voltage rage, from 7.2 to 12V, support  3S Li-Po battery

  • Support air-soft gun with sound synchronization

  • Support TAMIYA and HL IR battle unit and format

  • Support RealRecoil servo port

  • Support Recoil Solenoid for 2nd Machine Gun( MG2 )

  • G variant Support gun barrel stabilizer

  • Safety shutoff prevents unwanted movement while signal lost

  • Miniature design(60mm X 50mm X 20mm) for 1/25~1/16  R/C Tank

  • V2 Engine Sound Simulation

  • V2 Smoker driver

  • Adjustable Low Battery threshold

  • Adjustable ESC start voltage

  • Extend sound effect ( for E variant )

Terminology

Ultrasonic ESC is the ESC block which switch FET at ultrasonic speed, make motor rotation extreme  smooth and quite. start voltage of ESC can also be adjusted for different type of motor.

 

Adjustable ESC start voltage: offset can be added to ESC input vs. output curve to meet the characteristic   of motor

 

Carefree reversing: Unlike some other control board, there is no need for TK series board to delay before being commanded to reverse, can go from full forward immediately to full reverse or vice versa
 

EPM ( ESC/PWM module) is peripheral which can be switched to ESC or PWM mode, allows the user to drive brushed motor or servo motor, in ESC mode, ESC port is enabled, can be used to drive brushed motor, In PWM mode, PWM port is enabled to driver servo motor, sound effect stopped when servo motor reach end point, TK50 has 2 EPMs for gun elevation(EPM1) and turret rotation/gun traverses(EPM2),

 

EPM No.

ESC/Ultrasonic ESC port

PWM port

EPM15th and 6th Pin of CN9J4

EPM2

7th and 8th Pin of CN9

Note:ESC in EPM2 is

Ultrasonic ESC

J5

  

RealRecoil allows you to recreate real gun barrel recoil movement with single & cheap servo motor

 

Recoil Solenoid allows you to recreate MG/Auto cannon barrel recoil movement with Solenoid

 

V2 Smoker driver smoker fan/compressor speed is proportional to engine RPM and Load

 

V2  Mixer turning is achieved by reducing track speed and also increase opposite track speed to achieve smoother turning.

 

Adjustable Low Battery threshold cut off ESC output when battery voltage is lower than threshold, and threshold can be adjusted according to type and cells

 

Extend sound effect ( for E variant ) allows you to play 8 audio/music/voice

 

Momentum Effect to simulate inertia of tank hull movement

 

Product Identification System

 

DeviceTK50TK50 series Tank Controller



VariantBlankStandard

SS.BUS interface

PSound Programmable

A1105A track current ESC (CN6, CN7)

G2Support Gun Barrel Stabilizer

EExtend Sound effects

VSoftware revision



Sound PackT1Tiger I

KTKing Tiger

CH2_V1Challenger 2 ver. 1

.....Refer to TK Sound Pack webpage for more information

HL version 6.0/6.1 7.0/7.1  tanks:
you will need some parts as HL omitted and changed the wiring harness.
1) 8p daughter board + 8p wire
2) 2p x 3 to plug into TK board for battery power, and 2 motors.

PLEASE SPECIFY YOUR TANK SOUNDSET IN YOUR ORDER NOTES



you will need the FlySky FSi6S radio (S-bus) this comes with a 6 channel receiver, works perfectly with the TK50S, TK80S etc.
if you have this exact radio, just get a 6 channel iA6B receiver.

https://www.rctanklegion.com/collections/radio-transmitter/products/flysky-i6s-transmitter-and-receiver-set

more information:

http://www.clark-model.com/eng/index_e.html 

Your cart is currently empty.
Continue shopping